Certified Rejection Kit for Counter Tops Ab

Certified Rejection Kit for Counter Tops

Download PDF

STEP BY STEP INSTRUCTIONS: PREPARATION

____Step 1:

Recommended but not necessary to work in a ventilated room; (do not work near heat or flames if using Poly 300 Polyaspartic clear). Clean surfaces; remove any debris from countertop areas.

____Step 2:

Sand the surface with the supplied sanding paper. Wipe clean with rags to remove any sanding dust and debris. Fill fine cracks with PerformanceDIY.com caulk.

____Step 3: Prime Coat

Mix Part “A” in its original container for 2 minutes. Pour all of Part “B” into large clean container. Pour all of Part “A” into same container. Mix thoroughly for 3 minutes with the mixing tool for 3 minutes, paying close attention to all around the buckets sides and rising and lowering the mixing tool.

____Step 4:

Using the supplied squeegee spread the base coating material evenly over the counter to area, clean the squeegee well with a rag and xylene, as you will need it in step 9: DO NOT SOAK IN XYLENE THIS WILL DESTROY THE SQUEEGEE.

____Step 5:

Using the supplied 4” roller, roll out the base coating material evenly over the counter to area and the outer perimeter.

____Step 6:

After the entire base coat has been applied evenly, Apply the decorative flake chips conservatively, assuring even full coverage of flake chips. Two coats may be necessary on vertical surfaces.

____Step 7:

After 24 hrs. the excess flakes can be removed, and remaining flakes sanded to remove any high areas or excessive flake to create a smooth surface. Lightly sand the surface with supplied sanding block. Clean surface after sanding.